1.1. Go to Backup Sets.

1.2. Click the Add button.

1.3. Specify a backup set name and select the type. Click Next.

1.4. In the Filter part, slide the lever to the right to add a filter. Click the Add new filter button.

1.5. Enter the name for your filter.

1.6. Choose whether the pattern you added will be included or excluded for the backup.

• If Include them is selected, you can check the box beside Exclude all unmatched files/folders.

• If Exclude them is selected, you can check the box beside Include all unmatched files/folders.

Note: Please see examples to further understand how the filtering works.

1.7. Choose how the pattern will be compared, if it will be by Simple comparison or Regular expression. For Simple comparison you have 3 choices:

• starts with, files/folders that begins with the pattern will be selected

• contains, files/folders that contains the pattern will be selected

• ends with, files/folders that ends with the pattern will be selected

Note: The filter checks the whole filename including the filename extension. For example, you have a document with filename ‘employees’ so if ends with s is your filter then this file will not be included in the backup since its whole filename is ‘employees.doc’ or ‘employees.docx’ with both files not ending in s but c and x respectively.

1.8. Specify the pattern then click the Add button. For example the letter a. Repeat adding patterns, until all the patterns has been added to this filter.

Note: The pattern is case sensitive only in Regular Expression.

1.9. Choose how the filter will be applied, whether in All hard disk drives or for This folder only. If for this folder only, specify the folder name.

1.10. Select if the filter will be applied to File, Folder or both.

1.11. Click the OK button to save the filter. Repeat Steps 4-10 until all the filters you want to apply are created. Click Next.

1.12. Slide the lever to the right if you want to create a backup schedule. Click Next.

1.13. Select the Backup mode, whether Sequential or Concurrent. By default, Sequential is selected. Add the storage destination, click the Add button.

Select the Destination storage. Click OK. Click Next.

1.14. Slide the lever to the right if you want to enable OpenDirect. By default OpenDirect is turned Off. Click Next.

1.15. Select the Encryption Type, whether Default, User password or Custom. By default, ‘Default’ is selected. Click Next.

1.16. You can either Unmask encryption key or Copy to clipboard the encryption key. Click Confirm to continue.

1.17. Click Backup now if you want to run the backup. Or you can click Close.

2.1. Go to Backup Sets.

2.2. Select the backup set you want to add a filter.

2.3. Go to Source then slide the lever to the right under Filter. Click the Add new filter button.

2.4. Then follow Steps 5-10 on how to create the filter which was discussed in the previous section.